Skip to content
English
Go to welvaere.nl
  • There are no suggestions because the search field is empty.

Installing Natural Stone Under the Stove in the DIY Sauna

These steps describe the installation of natural stone in the sauna, with a distinction being made between a wood stove and an electric stove.

Installing Natural Stone with a Wood Stove

Attaching Natural Stone to the Back Wall:

  1. Apply Adhesive:
    • Apply four lines of adhesive to the back wall, directly above the floor, approximately 50 cm high and a maximum of 50 cm wide.
  2. Place the First Stone:
    • Place the first 60 x 60 cm stone against the adhesive.

Attaching the Second Layer of Natural Stone:

  1. Apply Adhesive:
    • Apply four lines of adhesive to the back wall directly above the first stone, approximately 50 cm high and a maximum of 50 cm wide.
  2. Place the Second Stone:
    • Place the second 60 x 60 cm stone against the adhesive.

Attaching the Third Layer of Natural Stone:

  1. Apply Adhesive:
    • Apply four lines of adhesive to the floor against the rear stone.
  2. Place the Third Stone:
    • Place a 60 x 30 cm stone against the adhesive.

Attaching the Fourth Layer of Natural Stone:

  1. Apply Adhesive:
    • Apply four lines of adhesive to the floor against the back stone.
  2. Place the Fourth Stone:
    • Place a 60 x 60 cm stone against the adhesive.

Placing Natural Stone Near an Electric Heater

Attaching Natural Stone to the Back Wall:

  1. Apply Adhesive:
    • Apply four lines of adhesive to the back wall, directly above the floor, approximately 50 cm high and a maximum of 50 cm wide.
  2. Place the First Stone:
    • Place the first 60 x 60 cm stone against the adhesive.

Attaching the Second Layer of Natural Stone:

  1. Apply Adhesive:
    • Apply four lines of adhesive to the back wall directly above the first stone, approximately 25 cm high and a maximum of 50 cm wide.
  2. Place the Second Stone:
    • Place a 30 x 60 cm stone against the adhesive.

Attaching the Third Layer of Natural Stone:

  1. Apply Adhesive:
    • Apply four lines of adhesive to the floor against the back stone.
  2. Place the Third Stone:
    • Place a 60 x 60 cm stone against the adhesive.

A detailed step-by-step explanation can be found in our manual.