How do you install the comfort furnishings in the self-build sauna with a closed back wall or half a panorama?

1. Outdoor bench placement:
   • Place the outdoor bench against the wall and screw it in with six 4x50 screws.
   • Screw each leg to the formwork with two 4x50 screws at an angle to the leg.
2. Attach Shelves to Outdoor Bench:
   • Screw the planks onto the legs with two 4x50 screws per board.
   • Use a 7 mm shims to keep the distance between each board the same.
   • The distance between the bottom board and the formwork is approximately 5 mm.
3. Indoor Bench Installation (Closed Back Wall or Half Panoramic Wall):
   • Place the bench against the wall and screw it in place with six 4x50 screws, both left and right.
   • Screw each leg to the formwork with two 4x50 screws at an angle to the leg.
4. Attach Shelves to Indoor Bench:
   • Screw the planks onto the bench with five 4x50 screws per board.
   • Use a 7 mm shims to keep the distance between each board the same.
   • The distance between the bottom board and the formwork is approximately 5 mm.
5. Confirm Backrest:
   • Screw on the backrest. The distance between the bottom of the backrest and the top of the bench is 20 cm.
   • Use four 4x60 screws for the backrest.
6. Repeat Steps 1 to 5 for the Other Side of the Sauna:
   • Follow the same steps to install the outdoor bench, indoor bench, and backrest on the other side of the sauna.
7. Installing Floors:
   • Install the floors. The 90 cm long floor is against the back wall.
   • There is no need to screw in the floors.

A detailed step-by-step explanation can be found in our manual.