How to Assemble the Full Panorama Window in Your DIY Sauna

Read below the steps you need to take to install the full panorama window in the sauna.

Installation Full Panorama Window:

1. Position the Window:

   • Place the panorama window in the rear groove. Do this with two people and ensure the window is as deep as possible in the groove.

2. Secure the Window:

   • Screw the panorama window from below with a single 4.5x60 screw.

Steps after Installing the Back Wall with Full Panorama:

Installation Crescent Profiles:

1. First Crescent Profile:

   • Place a crescent profile on the two walls. Ensure the walls fall into the groove of the crescent profile.

2. Left Crescent Profiles:

   • Piece by piece, place the left half-moon profiles on the left side and screw them down with two 4.5x60 screws per half-moon profile. Use a rubber mallet for a tight fit.

3. Right Crescent Profiles:

   • Repeat the process for the right half-moon profiles on the right side.

Upper Profiles Insert:

1. Place Remaining Profiles:

   • Place the remaining left and right crescent profiles without screws. Leave enough space on top to allow one more profile in between.

2. Remove and Insert Profiles:

   • Remove the upper middle crescent profile.
   • Place the last double crescent profile, using a rubber mallet to position it if necessary.

Attach Straps:

1. Insert and Hand-Tighten Straps:

   • Insert the tension straps and hand-tighten. Remove the screws in the formwork up to the slipper.

2. Tighten Straps:

   • Tighten the straps and, while tightening, hit the formwork with a rubber mallet to position it in the correct shape. Tighten the straps with an impact driver and wrench.

Attach Rain Leaders:

1. Install Rain Leaders:
   • Attach the rain leaders to the formwork on both sides with 4.5x60 screws, placing one screw approximately every meter.